WT-DIRECT starter set large carbon design for water transfer printing Contents:
1 x activator 1 x spray can lacquer 1 x primer 1 x 2 K clear lacquer 1 x WTD film 5 meters 1 x cutter knife 1 x work instructions 1 x sanding fleece 1x gloves beginners content
The water in the pool should have a temperature of 25 - 27 ° C, the soaking time is 60 seconds, there are 2 variants before the film is placed in the water then cut around with cuts at an angle of 45 ° at a distance of 2-3 cm At the end of the soaking time of 60 seconds, the film is sprayed with activator, and the component must be timelyThe pre-painting or priming is required for all parts that are not made of ABS plastic.
The water transfer printing film is ideal for providing complex parts with a decor / pattern, easy and easy to learn, even without a dipper / machine a coating is possible TOP QUALITY from WT-DIRECT GmbH if you want to order larger quantities simply the number of meters you need in Increase order window.
The film may look different in the original than in the photo in our shop. A result like in the photo can only be achieved if the part to be machined is inPart was pre-painted in the correct RAL color. Our foils / films are wound up on rolls. We recommend using our basecoat for parts that need to be painted, otherwise there will be liability problems